How to Factory Reset Deco XE75?

TP-Link Deco XE75 is a tri-band mesh WiFi system. It provides high level network performance and speed enhancement. In this guide on how to factory reset Deco XE75, we’ll walk you through the reset process, which is helpful if you’re troubleshooting, adjusting settings, or preparing to pass your Deco system to someone else.

Deco XE75 setup is easy, but if you ever need to restore it to default settings due to forgotten credentials or other reasons, a factory reset is essential.

Reset a TP-Link Deco system

If you want to reset the whole system, it can be done two ways, one via manual process and another through Deco App.

Reset Deco via Manual Process

First of all, you have to be quiet sure about this factory reset because doing so will erase all the customised settings which are irretrievable. There is a Reset button on the back of the device. With the help of a paper clip or toothpick press the button. Hold it for few seconds, about 30 seconds, power led on your TP-Link Deco XE75 starts to change colour. Wait for couple of minutes, your unit will set to its factory settings. Flashing blue light turn solid confirms the completion of process. Now the device is all set for installation once again.

Reset Deco from App

This is a quick process, if you want to reset the Deco XE75 system or just one or two unit, you can perform it via app easily. First of all install Deco App in your phone, Click on Network tab, and then go to Network map. Here, you can amend the changes as required.

While removing any prior set deco unit you will receive notification from the app, that this might reduce the WiFi range and you will lose all the previous settings. Click on Remove to proceed forth. Respective changes will take place; you will notice TP-Link Deco XE75 starts changing colours. Flashing blue colour confirms the reset and the device isall set for configuration now.

After the successful reset process, now let’s learn how to reconfigure Deco again.

Reconfiguring

• To perform the reconfiguring in easy steps with the help of Deco app, follow the steps as described below:
• Open the Deco app in your mobile phone; make sure it is connected with the network.
• You need to enter the admin credentials in the login window.
• Select the Deco model; you can start the configuration by feeding username and password and save the credentials.
• Connect all the Deco nodes and complete the setup or re-configure the setup.

There is one more way to reconfigure the TP-Link Deco device with the help of the computer or laptop via tplinkdeco.net or by using login URL.

Hope the information shared helps you to understand the factory reset process of deco xe75. If you want some additional information or feel lost at some point then do speak with the support team for assistance.